Install Telephony Module
OpenVox UC501 supports up to 2 modules. The UC501 series of products adopt modular design and are divided into new and old modules.
The optional modules are as below:
Old Module | New Module | |
|---|---|---|
Module Type |
|
|
| Info |
|---|
Note: Before installing the module, check if the module is clean and intact. |
1.Loosen the screws on both sides of the device.
...
2.Remove the upper cover.
...
3.The UC501 series of products adopt modular design and are divided into new and old modules.
Below is the top view of the inside of the motherboardchassis, and the right side is the module installation area.
There are four areas where you can install modules.
（1）For new module：users can choose any combination of the following three modules.
①FXS-200
②FXO-200
③FXOS-200
...
（2）For old module：The upper area is for the FXO-100/FXS-100 module and the lower area is for the FXO-400/FXS-400 module. It should be noted that the module cannot be installed on the left or right side at the same time, only supports ①+② / , ③+④ / , ①+④ / , ②+③.Users can choose two module accessories to customize.
...
4.Remove the screw and install the module (③+④mode).
...
FXO-100+FXO-100
FXO-100+FXS-100
FXO-100+FXO-400
FXO-100+FXS-400
FXS-100+FXS-100
FXS-100+FXO-400
FXS-100+FXS-400
FXO-400+FXO-400
FXO-400+FXS-400
FXS-400+FXS-400
...
Remove the screw and install the module(②+③mode).
...
4.After installing the module, close the cover. You’d better insert the chassis vertically as the picture shows, fasten it to the upper cover, and then fix the screws.
...