...
General Safety Instructions
CAUTION
- The computers that have A400E card installed must comply with the country's specific safety regulations.
- Only service personnel should go to install A400E card.
- Before installing A400E card, please unplug the power cord and remove the cover from your PC.
- For avoiding personal injuries and damages to your machine and A400E card, make sure bracket of the card is secured to the PC's chassis ground by fastening the card with a screw.
- Electrical Surges, ESD are very destructive to the equipment. To avoid it, make sure there is a low impedance discharge path from your computer to chassis ground.
- To reduce the risk of damage or injury, please follow all steps or procedures as instructed.
...
- Power off your PC, remember to unplug the AC power cable
- Set card ID as previously stated if there are more than one BRI card
- Insert B100P into a 3.3V or 5.0V PCI slot vertically
- Plug ISDN lines into RJ-45 interfaces which set as TE mode and ISDN phone lines into RJ-45 interface which set as NT mode.
- Fix the board by a screw
- Power on PC
Caution: If need to connect ISDN phone to B100P which set to NT mode, the phone must have the power supply function. During the above processes, an ESD wrist strap is needed. Once power is on, you must not attempt to install or take down the board. After hardware setup appropriately, it is time to install software.
...
# make install
# make config
Caution:If there is something wrong after "make", please refer toHERE. In the url link, the moderator introduces you a method how to patch. After patching, save your changes and exit. Then run "make" again, if successfully done, it is time for you to install Libpri and Asterisk.
...